Recommend reading through the stickies on thirdgen.org https://www.thirdgen.org/forums/diy-prom/

no, haven't done the cutting of the inner fender, that comes next. So it's not the sensor something else is affecting it. do you know of a video...

I'm not surprised it smells. It's running pig rich... your long term fuel trim (BLM) is pegged at the minimum 108 and the short term fuel trim (INT)...

installed a new knock sensor before this run. first half of log is without EST second half is with it. very stinky (fuel smell) in the garage,...

Unless the OP is saying that even his fan turn on temp didn't change? To the OP: What chip are you using? What chip burning equipment are...

Typically, changes to the fuel table and spark table provide improved performance. The attached Log File Analyzer-v32-18 is a great tool for...

So does that mean that I can use any bin I see fit? As in, I can use any EE 94-95 LT1 bin since all I have is the engine? Thanks for the...

1.) Leave as 6.0L, really that setting is only an indentifier not a functional code switch. 2.) Leave the settings the same as a 6.0L unless you...

You don't have to use the Cadillac calibration.

We are at the same point more or less. Have to clean up the PCM end of my harness, finalize my cooling system. About to decide between E-fans or back...

Vehicle had no radio, and no alarm or remote start. I tried removing all the fuses other then the ones essential to the PCM but I could not get it to...

Yeah... those kinds of things can often cause the knock sensor to react. Loose exhaust pieces, noisy rocker arms, etc...

this is a '56 GMC truck, and the inner fender wells haven't been trimmed right yet. when the engine runs, they vibrate against the upper control...

Yeah that looks much better... 15 inHg at @1300 rpm is about what I'd expect on that cam prior to any tuning. Once you get everything squared...

finally got it to run with the EST connected. the first log (5-10-2 ESC 2) has an #42 Error because it was from the previous run with EST...

Yes, using A217 $0D TP5 v250.adx, but has weirdness I'm unable to figure out. Please see attached .pdf for details. It would be nice to do real...

At this point something is seriously off with the engine (spark timing, valve timing or both). Recommendations: 1.) Carefully re-verfiy #1 TDC on...

new distributor, and it runs very well without the ESC. the log shows progression to closed loop from start, and several acc pedal stomps. ...

That's a great question! Did you view the log?

Which timing requires being tweaked? Usually a Copy / Paste using the difference tool. BDJZ 93 C-K Truck 5.7TBI 4L60e with 3.73 or 3.42...

Praise the Lord and blessed be the Father!! Very happy to report that it's alive!! Started up first try and and it runs like a swiss watch. I was...

Thanks for the input. Good idea Can someone else chime in? Wondering if I HAVE to use a Cadi bin please help

Some Table questions: 1. Scaler-Engine Type: Says table should not be modified but gives engine options so I changed it to match 5.7. Was this...

P59 vehicles can sometimes be difficult to read or write if they have aftermarket radios with after market chime adapters. Some remote start and...

Ok, so the Tequila last night must have helped clear my head... LOL. Tried to just save the 6.0 .bin without modifying it. It still threw the...

And I also have no idea how to tweak the existing timing that's negative! Lol