Quote Originally Posted by Nasty-Z View Post
Wired up the TCC in the Orange Blazer last night , set all of the checkmarks in T/P for 700R4 control and viola , pin E13 shows TCC lockup at the parameters specified , this is good .

Problem is on the datastream dash the TCC bitmask (TCC applied) does not show "True" , it stays False all the time .

Am I missing something ?

496/700R4 combo , Running a modified hybrid $OD .bin , $OD TP5 v250 .adx

Also , the speed (MPH) bounces alot in the datastream , i'm sure this will not be good long term , the speed sensor is the factory cluster mounted sensor inputted to the PCM @ F13 and the cluster is cable driven from the transfer case , cable is new . Anyone remidied this without going to an aftermarket speed sensor (which I will if I have to) .

Any clues ?

Thanks

TOM
Tom,

It has been years since I ran a 7427 with a 700r4, but I seem to remember the Flag for TCC being on the PWM output and it was once defined as "Lock Adjust" When the TCC was commanded to lock, it would display Lock Adjust as "Active"