THEY are NOT Lying to You.
You are NOT Even Lying to Yourself.
You ARE Being Lied to ... by Your SELF.
The Last Psychiatrist, aka ... Alone ...
I'm certainly no expert in this but I think I've got it under control with the help of everyone here, so thanks.
I made adjustments to tables which now command WOT shifts at 5000rpm. There's still a delay in the shift action but it happens between 5500 and 5800 pretty consistently. It feels much better since the engine is just below to top of the power curve. So, as far as command and action is concerned, there's a delay. However, the seat of the pants sensation gives no concerns, it feels good. That "hang time" is gone.
I saved a screen shot of the tables with the changes I made so you can criticize if you think its necessary.
I also posted a data log file of a short drive with a few WOT's including 1-2's and 2-3's. The WOT events are at #1355, 1872, 3442 and 3716. If you see anything wrong or concerning in the log, please tell me.
trans adjust completed.jpg
I cant get the data log file posted. I'm not sure why it wont upload
try setting your shift times to 0.300
EDIT: changed number not sure if your 4L60E is stock,built, shift kit etc
Last edited by tayto; 08-23-2021 at 06:55 AM.
Do not see where you adjusted the corresponding KickDown road speeds in MpH.
If 5000RpM turns out to be under the road speeds in your KickDown MpH table, MpH becomes the final criteria that triggers the WOT UpShift.
(I find 26" tires irksome. What is your tire size?)
With 4L60E, 3.73, & 205/65R15 (25.49" tall) @ 5000RpM:
1Up2 @ 33MpH
2Up3 @ 62MpH
3Up4 @ 101MpH
Once the TPS% exceeds KickDown Threshold, the VSS exceeds 33MpH / 62MpH / 101MpH, then the engine exceeds 5000RpM, THEN the WOT 1Up2 UpShift gets commanded and STARTS.
If the KickDown road speed thresholds are over 5000RpM, MpH becomes the final criteria that triggers the UpShift.
Errors in the speedo constants can leave you thinking your final criteria is RpM, when it's actually MpH.
Last edited by LeMarky Dissod; 08-23-2021 at 08:09 AM.
THEY are NOT Lying to You.
You are NOT Even Lying to Yourself.
You ARE Being Lied to ... by Your SELF.
The Last Psychiatrist, aka ... Alone ...
Ok, I’ll check out the kick down road speeds too, thanks.
Bottom line is, before the shift was too late. Good quality shift but too late. The engine was going flat s second or two before the shift. Now, it’s shifting right before the engine flattens out. Nice solid shifts and not too harsh.
The 4L60e always seems to have a delay between the PCM deciding to shift and the shift finally occurring, even after tuned. I find I put the 1-2 shift 200-300 rpm lower than the 2-3 shift for them to actually happen around the same rpm. With the delay, the engine rpm is climbing faster in 1st so the shift needs to be done a little earlier.
THEY are NOT Lying to You.
You are NOT Even Lying to Yourself.
You ARE Being Lied to ... by Your SELF.
The Last Psychiatrist, aka ... Alone ...
Yes, it's transport delay, it happens electronically and mechanically. Adjust to suit :)
-Carl
Bookmarks