But I'm trying like everyone else to make this headache work... I'm already out the money
it seems pretty obvious that this software is effective. I did homework on a standlaone system and 900 is a little light IMO. that being said, I have what I have and I firmly believe it will work at some point. It's a simple problem and there's more than likely a simple solution and then I can move onto the next challenge. I certainly didn't think I'd be stuck this far this early one, but it is what it is.
I have basic connectivity established via the adld cable , so I am able to see a dashboard with data coming from the truck.
That being said, at this point I think it's safe to say that I have the correct files loaded . ADX ADS. I pulled them right off of Tunerpro. Here's a question. Some of my observations prove to me that I wouldn't be able to connect if I had the wrong file..
NOW, I also have BIN file downloaded to my PC, one that is from a stock truck of the same genre.
Instructions tell me to put a chip in teh box and hit upload. the upload button is not lit. HOWEVER I am not connected to the vehicle , Do I have to be ? and if so do I have to be connected via the ribbon to the ECU and the ALDL cable as well. It appears as though from what gentlemen said I shold hook her up. THis didn't make logical sense to me at first because in my eyes the truck wasn't looking at any data, because A. I have no BIN on the chip B . the g1 adapter tkes that chip out of the mix IMO.
So one of two things is true . I am able to UPLOAD a BIN to a chip WITHOUT being connected to ECU and I;m just screwing up somewhere
OR, once I connect to the ECU some magical thing happens and I will be able to upload a config and all the stars will magically align. THis makes no logical sense to me.. BUT I will try it if I can get a small assurance that it can be done
at what stage are you at? are you further than me? It's a like a video game, we're breaking through levels, and this level is a bit tough, but the next level maybe we'll get an extra weapon or magical power .. right? that weapon may be this message board .
I own an Ostrich 2.0, which uses a ribbon cable connected to a G1. See attached pictures.
An accomplished tuner will use a Wide Band Oxygen Sensor (WBO2) for ALL EFI System, OBD1, OBD2, and Aftermarket (including the slow learning / auto tuning EFI systems).
dave w
I appreciate your answer but I'm so not there yet... I can't even get a BIN on a chip... I sent a letter to Moates... we'll see how that goes.. these dipswitches could be the culprit, or perhaps the box is bad... I'm reading the help files within TP to try and gain some knowledge.
Tehse switches should be laberled and a chart made, perhaps once I figure this out I will make such chart... I'd love to get to a point where I could provide some help to knuckleheads like myself
Bookmarks