so newbie it hurts. need some help with open loop

[Mark1978]

I think I messed up something with the burn process. Maybe I accidently changed a setting or something. The chip that I was using to datalog works fine. So I copied it to a buffer and then burned it to a fresh chip-no dice. Maybe I need to uninstall tunerpro and reinstall it? I dunno. I did do a compare but I honestly could not find anything that would stop it from datalogging. Here are a few bins

[dave w]

I think I messed up something with the burn process. Maybe I accidently changed a setting or something. The chip that I was using to datalog works fine. So I copied it to a buffer and then burned it to a fresh chip-no dice. Maybe I need to uninstall tunerpro and reinstall it? I dunno. I did do a compare but I honestly could not find anything that would stop it from datalogging. Here are a few bins

Try burning a new chip with injector flow of 59 instead of 57.3. Injector flow changes are HUGE, I recommend small increments when making changes to injector flow parameters.

dave w