Mother of all 7603 XDF files

[coldsteelmike]

I've done 3 things here:

1) Moved the ETC-related parameters out of the idle section and into a new "Electronic Throttle Control" section under the Engine Calibration section.
2) Added two PTO parameters to a new "Power Take-Off" section.
3) Replaced the checksum stuff with what was in DzidaV8's XDF, because it uses built-in Tuner Pro checksum code rather than a DLL.

The data in table B6614, "Max Torque By RPM Vs Fuel E%" looks to me like the XDF should have two more rows in each E% column, but I haven't figured out how to fix that.

Speaking of ETC parameters; is there any way that we could get the 'Parameter Comment' section filled in for these two (ETC Option & ETC Present) flags?

I'd do it myself, but I am unsure of what they do. I've found contradiction in their setting and the 'Vehicle Platform Options' table that outlines that a PCM Calibration does indeed have Electronic Throttle Control present.

Thanks for any direction you can provide.
ETC Option.jpg

[persingc]

Speaking of ETC parameters; is there any way that we could get the 'Parameter Comment' section filled in for these two (ETC Option & ETC Present) flags?

I'd do it myself, but I am unsure of what they do. I've found contradiction in their setting and the 'Vehicle Platform Options' table that outlines that a PCM Calibration does indeed have Electronic Throttle Control present.

Thanks for any direction you can provide.
ETC Option.jpg

Download the new Version4.zip from the top of the page. I think I pulled those when I saw they weren't correct.
I'm bad about forgetting the Parameter comments. I'll see if I can pull them in a bit... and as much as it pains me make a Version 5.

[coldsteelmike]

10-4. I see it's gone.

I'll be flashing my PCM for my LS Swap here soon. Going for a first fire before Christmas.

[NSFW]

Don't worry about extra versions. It's great that you're still iterating on it.

It's not reasonable for anyone to expect something this big and this complicated to be perfect on the first shot.

[persingc]

10-4. I see it's gone.

I'll be flashing my PCM for my LS Swap here soon. Going for a first fire before Christmas.

Version 5 with additional ETC parameters and comments.

[coldsteelmike]

Solid!

Merry Christmas to All!

[persingc]

Solid!

Merry Christmas to All!

How did your first fire up go?

[coldsteelmike]

How did your first fire up go?

It went off without a hitch. Removed fuel pump relay, cranked engine over with starter until I showed oil pressure on the gauge. Replaced relay, and primed a couple times with the key set in Run. Twisted her to start and she fired up strong and idled down perfectly. All well!