If all goes well, I will test it out this weekend. I'm going to have to tweek my fan mount just a tad then finish wiring it up.

I downloaded your XDF. So all I have to do is hit apply patch and its done? I did that and saved it as new.
I will not be using soft start (I'm using a standard relay) what do I need to do to make sure its set correctly, I have plenty of relays, but I dont want to burn them up.
The flags, what are they for, do any of them need checked?
The scaler, engine fan code, says to change from D399 to 7019, but it was not changed after I applied the patch. Do I have to manually change that value?
Same thing for the trans fan, it has two scalers that say trans fan code. I will not be using the trans fan, I only have 1 fan.
Are these scalers to turn on the function?

Last, what, if anything, has been removed or replaced by this code? The variable manifold tuning controll? Just want to make sure it didnt remove something I am actually using (like ccp or something like that) and make sure if I change another parameter it wont mess up the fan/code.