Homemade injector flow bench: https://www.youtube.com/watch?v=e_g9K0VEsfE
http://www.youtube.com/watch?v=zBYMtJO0pX8
I'm getting warmer.
1st things first. with a g1 adapter I need to have a chip with a bin on it because it seems impossible to get that config off that chip without removing it.. agree?
2. Followed directions withing tunerpro, they seem better than any vid ( at least for me) . UPLOAD button never lights up. So, does this ribbon cable need to be connected or can I can do it from my Lazboy?
and if the ribbon cable needs to be connected, how does the truck have anything to run off of?
I'm missing something or overthinking it.
My understanding is you have a APU1. Does your laptop detect APU1 hardware down at the bottom of TunerPro RT? You need to establish this connection by messing with the COM port on your laptop and preferences in TPRT. With the ribbon connected to G1 and G1 inserted into PCM, you should be able to load any bin into the emulator and the engine will be running off of the bin you just loaded to emulator.
But I'm trying like everyone else to make this headache work... I'm already out the money
it seems pretty obvious that this software is effective. I did homework on a standlaone system and 900 is a little light IMO. that being said, I have what I have and I firmly believe it will work at some point. It's a simple problem and there's more than likely a simple solution and then I can move onto the next challenge. I certainly didn't think I'd be stuck this far this early one, but it is what it is.
I have basic connectivity established via the adld cable , so I am able to see a dashboard with data coming from the truck.
That being said, at this point I think it's safe to say that I have the correct files loaded . ADX ADS. I pulled them right off of Tunerpro. Here's a question. Some of my observations prove to me that I wouldn't be able to connect if I had the wrong file..
NOW, I also have BIN file downloaded to my PC, one that is from a stock truck of the same genre.
Instructions tell me to put a chip in teh box and hit upload. the upload button is not lit. HOWEVER I am not connected to the vehicle , Do I have to be ? and if so do I have to be connected via the ribbon to the ECU and the ALDL cable as well. It appears as though from what gentlemen said I shold hook her up. THis didn't make logical sense to me at first because in my eyes the truck wasn't looking at any data, because A. I have no BIN on the chip B . the g1 adapter tkes that chip out of the mix IMO.
So one of two things is true . I am able to UPLOAD a BIN to a chip WITHOUT being connected to ECU and I;m just screwing up somewhere
OR, once I connect to the ECU some magical thing happens and I will be able to upload a config and all the stars will magically align. THis makes no logical sense to me.. BUT I will try it if I can get a small assurance that it can be done
at what stage are you at? are you further than me? It's a like a video game, we're breaking through levels, and this level is a bit tough, but the next level maybe we'll get an extra weapon or magical power .. right? that weapon may be this message board .
http://support.moates.net/hdr1/
You can use some creativity if you don’t want to purchase a HDR1...
Last edited by stew86MCSS396; 03-30-2018 at 12:48 AM.
I wish they had of told me everything I needed... last week it was G1, now it's HDR1, whats next... I'll pay the money, that's not the issue, just tell me. ( Moates) not you.
Actually you don't need it if you can find the same bin or something similar to what you need at this link: http://www.gearhead-efi.com/Fuel-Inj...Information-0D
Just download and upload to emulator.
Bookmarks