DIY LTCC or similar system for LT1s

[Terminal_Crazy]

Just watched the videos. Looking Good.

Will this allow the motor to rev over 7K or is that limited by the PCM ?

Thanks
Mitch

[kur4o]

Just watched the videos. Looking Good.

Will this allow the motor to rev over 7K or is that limited by the PCM ?

Thanks
Mitch

The PCM will freak out at 7228 rpm. Beyond that the opti signal might be too corupt or the PCM too slow to read it.
Most of the tables will be maxed at 6000-6400 rpm too.
The opti signal is capped at 7228 rpm and the injectors at 7245 rpm in the code. These limits can be raised but the engine operation might become unstable.

[Terminal_Crazy]

The PCM will freak out at 7228 rpm. Beyond that the opti signal might be too corupt or the PCM too slow to read it.
Most of the tables will be maxed at 6000-6400 rpm too.
The opti signal is capped at 7228 rpm and the injectors at 7245 rpm in the code. These limits can be raised but the engine operation might become unstable.

I've just checked my logs from today.
I thought i was abusing the motor but i only just managed to turn 5500 whilst logging for the VE tables.


Mitch