I have a '94 S10 blazer, W Code L35 CPI 4.3L it has an aftermarket Remanufactured ECM labeled "7-6395"
MemCal labeled BUZX 1623 9420
I downloaded the A178 ADS file, converted to ADX.. but when I datalog, Things like MAT (ASSuming this is the same as IAT, since IAT ins't listed) just shows 128C
Coolant Temp -40. TPS values are all over the place, Desired idle speed is just "2675" Yet, when I view live data using my Tech1, I see correct values, so I'm certain the issue is with the ADS file...
is it possible to look at the raw data from the ecm and compare it with what my tech1 reports to try and locate the correct values in the stream? I.e if my tech one report coolant temp as 5^c (key on, engine off so it isnt like to change quickly) then look at the datastream to try and find a matching value?
Bookmarks