what am i doing wrong?

[CapriceLT1]

-Turn Ignition on
-Plug in cable
-Start Tuner-pro RT
-Make sure my 95COP.bin is there and the xdf is there.
-Initialize hardware, it connects. Load ADX
-Click on blue arrows
Same thing happens all 3 times with new ADX's from EagleMark. Could it be XDF?
I disconnected and re-connected after i changed each ADX.

It still says errors and won't show the Dash/graph monitoring system live. The cars idling at around 700 rpm and it still says 0. I want it to work soooo bad :(

[gregs78cam]

Try a different USB cable. I had issues with uploading and verifying in the camaro on occasion and swapped USB and haven't had a problem since.

[EagleMark]

Maybe! But lets do it right first!

First you do not need an XDF file or a bin file to data log.

Next your pushing to many buttons again!

-Initialize hardware, it connects.

That's the same thing as emulate, you don't have any hardware to Initialize, all you have is a cable which needs nothing more then clicking the double blue arrows...

Rinse and Repeat!

Make sure cable is in USB port and found in TunerPro, USB ports can move around... if TunerPro can't find it move it to another USB port, then click connect/blue arrows.

[CapriceLT1]

F'n ay lol. Ok the button i am pushing to find the cable is the one i am pushing. It finds it. Its on the same row as the blue arrows and looks like an ALDL cable end


http://www.ebay.com/itm/GM-OBD1-Scan...e71420&vxp=mtr

thats the cable i am using

[EagleMark]

No your clicking the button to Initialize Emulation Hardware. You don't have emulation hardware and if you did you can not emulate the LT1 PCM.

All you have to do is set the cable up correctly from Tools, Preferences, Data Acq/Emulation.

[CapriceLT1]

tool/preferences same setup as what the pic shows. still nothing on the dash. Error keeps occuring so i stopped hitting the blue arrows went back and switched to autoprom mode or whatever and dashes still showed nothing but when the DA was connected it was blue and no errors occured. I do test for valid interface using the settings and it says the cable is connected and ready to be used.

If i have the settings set at what you have in the pic above, then press the 2 blue arrows and DA errors occur but is connected but dash shows nothing then....

[EagleMark]

Did you test for Valid Interface Using settings? This is how you test the cable...

Have you looked to see what Com port the cable is on?