LOOKING FOR A BENCH HARNESS FOR A 1997 CHEVY LT-1 OBD2 TO BENCH PROGRAM PCM:
Does any one have a diagram or links to some videos for me. thanks
LOOKING FOR A BENCH HARNESS FOR A 1997 CHEVY LT-1 OBD2 TO BENCH PROGRAM PCM:
Does any one have a diagram or links to some videos for me. thanks
same as an OBD-I but different data pin
red connector: pins 2 and 18 ground
black connector: pins 15,30,31 power
gray/clear: pin 32 ground
blue connector: pin 1 ground, pin 3 power, and pin 7 is your OBD2 data
im sure all the grounds aren't that necessary but i connect 'em anyway
here are some diagrams (covers all 1994-1997 LT1 ecms)
http://shbox.com/1/4th_gen_tech2.html#1995_pcm_pinouts
What a great link, steveo.
Here is some more info that might come in handy.
Code:LT1 OBD1/2 Red pin 2 Ground Red Pin 7 Fuel Pump enable to relay +12v out Red Pin 25 Fuel Pump enable VATS Black Pin 6 Analog Ground Black/White Black Pin 15 12v Constant Red Black Pin 16 Analog Ground Black/White Black Pin 28 5v Black Pin 29 5v Black Pin 30 12v Switched Purple Black Pin 31 12v Constant Red Blue Pin 1 Ground Black Blue Pin 3 12v Switched Purple Blue Pin 7 Serial Data <<<<< OBD2 Blue Pin 9 MIL Blue Pin 20 Output/Field Service Enable (Diag Port) DLC Pin 6 ckt 448, ,Pin C C230 Blue Pin 29 Serial Data <<<<< OBD1 Blue Pin 30 Serial Data <<<<< OBD1
-Carl
For a bench setup, you might want to have a switch for the source connected to Black 30/Blue 3. The PCM doesn't power the processor and most other circuits until this ignition circuit is applied. When it is removed (key off), the processors continue to run until an internal reset is generated. There are several ways this can happen. Once the reset occurs, the Power Management IC (PMIC) removes power from most of the internals.
If you plan an "open case" bench setup, it is a good idea to connect grounds between the "T"side and "E"side. This grounding is usually taken care of by spring clips between the boards when sandwiched in the case. If you remove the boards from the case the ground needs to be re-connected. In most cases this will be OK just through ground connections to each half. Should you be drawing more current from some of the drivers though, a ground shift can happen and cause unexplained faults. To do this I just make bare some of the copper ground hatch and solder a wire between boards.
Tom, as always, valuable information :)
There should always be a constant BATT power and then IGN power via a switch since EVERY ecu does "housekeeping" on key off.
-Carl
Bookmarks