I'm working on developing an external crank trigger to allow for the installation of a 24x LS1 wheel on a 60V6, using the LX5 "Shortstar" sensor, which has a dual 24x output, one high, one low.

My plan is to make an arbor to hold this wheel:

https://www.summitracing.com/parts/n...QaAmV5EALw_wcB

and then a simple sensor mount, should be an easy enough part to make. I'm also going to see if the engine will run with only one 24x input instead of both, if that's the case, a LX9 V6 could be run with the earlier V6 PCM without an external trigger, or a aftermarket PCM.