Hey all,
Me again, sorry for flooding with posts but I'm trying to get to the bottom of all of this.
Since I've put a socket onto my PCM (so I can use a socketbooster and ostrich 2.0) I'm not able to connect to my PCM to datalog. Obviously I've reinserted the standard chip, to check everythings good. I have an android tablet that's hooked up to a 1320 ALDL bluetooth adapter, worked perfectly before this, for over a year. But now it seems to connect to the bluetooth device but not capture any data from the PCM.
The van starts and runs, but not well, it was running perfectly before using the standard chip.
The van runs on the Ostrich 2.0, but again, not particularly well. Problem is, now I can't view any data logs to find out WTF is going on?!
Is it possible I could have damaged my original chip some how? Any ideas at all?
Also, the Check Engine Light seems to stay on, I've tried jumping pins A&B and switching to run, but it just stays on.
Again sorry for all the posts. I'm learning.
**Upon further investigation, I've discovered the van will run without a chip in the PCM. It appears to be running the same with a chip or the ostrich 2.0 or without, so.... is it fucked?
Bookmarks