Hello,
New to this forum environment but have done quite a bit of home brew tuning with GM 1227747 and 1227730 ecms. Are there any $E6 binaries around so I can start playing with a new ecm?
Hello,
New to this forum environment but have done quite a bit of home brew tuning with GM 1227747 and 1227730 ecms. Are there any $E6 binaries around so I can start playing with a new ecm?
I'd mess with the $0D binaries. The $0D will run in the 16168625 PCM, has more work put into it and thus more tune ability. There are also more stock $0D binaries for download on this website compared to $E6.
http://www.gearhead-efi.com/Fuel-Inj...Information-0D
Thanks c5wagner I'll dig into the $0D binaries. I have an ecm with the V6 calpak so i have to find a V8 one to install a flash chip on. I will let you know how things progress. Again thanks for the info!
I sort of remember a document floating around(years ago, probably close to 20 years) so you could modify the NETRES(Limp, resistor network), basically mimic what GM did with the 305/350/454, of the memcals. Does anyone have a copy or link to the information?
-Carl
A number of people worked together here to get through some of the old info and some new info to come up with this:
http://www.gearhead-efi.com/Fuel-Inj...ull=1#post2855
This may be some of the original documentation you are remembering:
https://web.archive.org/web/20030216...ECM/inj_op.htm
Interesting. The 5.0 identifier "27" hasn't been listed before.
http://www.gearhead-efi.com/Fuel-Inj...your-Memcal-ID
There is a pile of good memcal information in that thread. Post 19 has a number of good files with it.
http://www.gearhead-efi.com/Fuel-Inj...ll=1#post21015
Bookmarks