I have continuity from 26Red pin to ICM white wire, ICM WHT/Black to Coil, and ign power with key on to both, also good ground to ICM. so the only thing left is what signal to test for and how from PCM. if that's good, then what signal does the ICM send to the coil and how to test that?
so I think I figured it out. I tested the signal from the PCM with an LED and it was goo. so tomorrow I will get and ICM and that should fix it. it is quite a coincidence for that to go bad at the same time that I decided to do the swap.
Bookmarks