I will do as you suggest.
Looking at the fuel injector calculator on WitchHunter's site, it would seem I need around 100 lb/hr of injector output. Do you feel this is about right?
Between all the hard parts I have sitting around, I can get to about any injector rate. The company that tuned my truck put in my 11 psi spring with one of my smaller injectors so they are probably around 62 lb/hr. I have another set that put out 75 lb/hr at 11 psi. I also have a few springs, 13 psi, 14, psi, 18 psi, and an adjustable regulator. The larger injectors with the 18 psi spring puts my rate near 96 lb/hr. I can use my adjustable base to bump up from there if needed.
Funny part is looking at the same calculator on WitchHunter's site given my current injector and pressure it suggests it should make near 230 hp crank. Really not too far off looking at the dyno sheet.