That's it! I'm effing done with this ECU! Going to megasquirt!

[Stokes1114]

If I were to change computers, I would use the '0411 PCM. I've designed and built a plug-n-play crank position sensor kit to fit the L31 Vortec distributor, which makes upgrading to the '0411 very easy and affordable. See attached pics. Basically, the '0411 is flashed with a modified 2002 Express Van L31 5.7 liter tune. The crank position sensor kit, with new distributor, is on par with the cost of a MegaSquirt system.

dave w

If you dont mind me asking, Are you going to be selling these crank sensor kits?

[dave w]

If you dont mind me asking, Are you going to be selling these crank sensor kits?

Yes, I will be selling the crank sensor kits. The production crank position sensor housing is 3D printed with Black High Temperature Glass Filled Nylon material, which is similar to the distributor cap ABS material. The prototype, which is pictured in my previous post, was 3D printed with a material called All Temp. http://www.goengineer.com/3d-design/...FRl2Xgod9pAPow

dave w