I have not looked at the files, but I noticed the .bin file size is 32K. The stock $OD .bin file size is 64K.
dave w
I have not looked at the files, but I noticed the .bin file size is 32K. The stock $OD .bin file size is 64K.
dave w
I keep getting the same 32K result. Here is a file that was labeled from last Jun. Before today, it was the newest one I have. Organization is not my strong suit.
Please, don't use the files posted above, they are garbage. Here is a BIN and XDF file that will work. This XDF has a 3 wire vortec MAF table in it, however, I'm running this bin with a 5 wire 5.3 MAF and it runs. If you want to run a 4L60E and MAF the key is the code located on the line that starts with AD40. AD48 is the start of the 4L60E shift parameters and needs to read 03 02 00 01 (view in HEX Editor). If your BIN doesn't have that, no amount of table tweaking will get the transmission to work. The first BIN I posted did not have the correct code in it. Hope this helps someone.
/r
Jim
Does the knock sensor work on this? I tried to re-enable it and built a bin from the source code. But i haven't tested it yet.
I believe it does. I never messed with the underlying XDF file other than change the MAF table to a 3 wire vortec MAF.
Bookmarks