I can test this, I have some LT1 cars to play with in the neighborhood...
I can test this, I have some LT1 cars to play with in the neighborhood...
The idle open loop patch cell 16 is working very good. It doesn`t need an improvement for now. Maybe next release will be idle open loop cell 16 running SD mode, for maf running cars. I noticed that idle in SD mode is so much better.
Meanwhile I made another patch,
It forces SD mode while keeps display of Maf readings and adds display of VE table calculated airflow. I want to add a MAF frequency display too and it will be released.
As you can see on the screenshot VE tables are maxed out by 10%. What will be the best tuning strategy in that case. Increase of cylinder volume?
Steveo if you want to add the new patch in eehack I can give you details.
I test the eside ALDL patch. It works only at engine off. When engine is runnig processor is too busy to stream data.
In that case we can load eside custom tables when engine is off.
Dzidav8, thanks for the support. When I come up with something new you will be the test mule.
So here is the latest patch.
There are two version. All tested and working.
Make sure you follow instruction exactly as written.
Use attached definition file with eehack. First rename it to .csv format.
Important info for MAF patch only, since it reconfigures some aldl bytes wideband on pin D27 won`t work(It will work fine with sd patch).
There is workaround though but it is complicated.
Last edited by kur4o; 08-26-2017 at 10:47 PM.
Bookmarks