I can't thank you enough. Had I known about the prime pulse width table(s) not referencing injector constant it would have saved me dozens of E-side flash cycles and a lot of frustration. I got close enough on the first attempt by scaling VE and the prime table according to what I thought would work that I'm not sure fine tuning will be needed. I'll report back once it cools to 60c.
Since it sounds like you've done a few of these, are there any other pitfalls you can think of warning me about?
I also applied all the SD / VE logging I've done since the injector swap, which produced some changes in the neighborhood of 5-6%. I was looking for a distinct pattern of shifting from lean to rich with RPM that would indicate having the wrong offsets, but saw nothing of the sort.
From here I'm off to building a vss + gps driven arduino based performance computer so I won't have to rely on butt dyno "numbers".
Bookmarks