In the process of converting my Truck to EFI, I needed a VSS signal, so the most cost effective way for me was to have a ring made to mount on the front driveshaft output flange. When I sent the file off to be cut, I knew it would not cost much more to have a few extras made, so I went ahead with them. I have 4. These are 16gauge, and have 40 teeth, and fit in between the front output flange, and CV yoke flange on NP203, or on the rear output flange, if you are using a CV yoke on a NP205 or NP208. $15 shipped.
HUB Bore Dia. 3.125"
Bolt Circle. 4.25"
Bolt Hole 7/16"
Outside Dia. 6.75"
If OD is an issue, I had contemplated bending the tabs 90*, and mounting sensor at 90* also, but I do have enough room as is.
EDIT: If you need a different size ring made, Please contact me with dimensions/specifications and I will gladly make up a drawing, get you price, and have it cut if you like.
Greg
Bookmarks