Originally Posted by
steveo
Let me know if you have any trouble getting qt going.
Thanks, working on it now.
Code:
case VEHICLE_Y:
if(debug.verbose()) debug.print("SILENCEY CCM");
display_event(QStringLiteral("Silence CCM"));
for(int x=0;x<3;x++) {
force_raw_shutup_request(0xF1);
wait_for_silence();
sleep_ms(75);
}
if(debug.verbose()) debug.print("SILENCEY ECM");
display_event(QStringLiteral("Silence ECM"));
for(int x=0;x<3;x++) {
force_raw_shutup_request(PRIMARY_ECM);
sleep_ms(75);
}
break;
I did notice this in the version I grabbed from github. Isn't there also a body control module in the vettes that can talk on the aldl?
I've read most of this thread but I have several irons in the fire at the moment so apologies if I overlooked the answer to this question, but has logging and / or flashing ever worked correctly on the y bodies without pulling CCM / BCM fuses? My initial need was to log so I can tune the idle air bypass in my aftermarket throttlebody. When I first fired it up and logged an idle warm up sequence I noticed a few errors in the first few minutes of logged data, but about 5 minutes in the wheels came off and all sorts of errors cropped up - see frame 1098 below. I'm wondering if this might be one of the other modules on the bus "waking up"?
Code:
MALF43A(MALF 43A ACTIVE)
MALF43C(MALF 43C ACTIVE)
ERR23(MAT SENSOR LOW)
ERR16(LO-RES FAILURE)
ERR13(LEFT O2 SENSOR FAILED)
ERR12(NO REFERENCE PULSES)
ERR11(MALF INDICATOR LAMP (MIL) FAULT)
ERR48(MASS AIR FLOW SYSTEM FAILURE)
ERR32(EGR SYSTEM FAULT)
ERR61(A/C LOW CHARGE)
ERR55(FUEL SYSTEM LEAN)
ERR50(SYSTEM VOLTAGE LOW)
ERR45(LEFT O2 SENSOR RICH)
ERR69(A/C CLUTCH CIRCUIT OPEN)
ERR68(A/C RELAY SHORTED)
ERR67(A/C PRESSURE TRANSDUCER DEGRADED)
ERR66(A/C PRESSURE TRANSDUCER OPEN/SHORT)
ERR65(RIGHT O2 SENSOR RICH)
ERR64(RIGHT O2 SENSOR LEAN)
ERR63(RIGHT O2 SENSOR FAILED)
ERR62(OIL TEMPERATURE HIGH)
ERR78(FAN 2 FAULT )
ERR77(FAN 1 FAULT )
ERR71(A/C EVAPORATOR TEMP SENSOR FAILED)
ERR70(A/C CLUTCH RELAY FAULT )
ERR34(MAP SENSOR LOW)
ERR33(MAP SENSOR HIGH)
ERR37(BRAKE SWITCH STUCK ON)
ERR14(COOLANT TEMPERATURE HIGH)
Bookmarks