I can probably find another unit here soon, I have another one that will control a 4l60E.
I just bought the winflash software and have been using it, but am keen to give this a try once it is a little further along on the v6 side of things.
I can probably find another unit here soon, I have another one that will control a 4l60E.
I just bought the winflash software and have been using it, but am keen to give this a try once it is a little further along on the v6 side of things.
flash write might be slow to get going on the v6 side but i will get it working eventally..flash read is already kinda working, i did that as a special project for kur4o, it reads a lot of unneccessary regions, and saves it as an lt1-like bin.
i suppose any would do, i never really plan any transmission functions; i'd just plug it into a bench testing setup.I can probably find another unit here soon, I have another one that will control a 4l60E.
i really dont know a lot about the v6 ecms, i'd learn if there was one in front of me, but better yet i should buy a car with one, that'd get it going.
Steve, you use IDA? I can upload both halves of my disassembly, be easier to explain things that way. my P66 V6 ADX has some mode4 stuff in it already but I have more defined in the disassemblies than what I have in the ADX.
stuff I can answer off-hand: the T-side does primary communications, mode4 stuff is passed to E-side over SPI. E-side mode4 bytes are 360-366, T-side mode4 bytes are 34A-355. I've got a decent amount of both decoded.
BLM cells are located from 100-142 on E-side(an odd byte exists between the cell groupings, it might be an idle only cell?). 100-10F are Right/Rear O2 sensor with CCP active BLM cells(1-16), 111-120 is " .... " with no CCP, 122-131 is Left/Front O2 sensor with CCP active, 133-142 is " ...... " with no CCP.
1995 Chevrolet Monte Carlo LS 3100 + 4T60E
i do have ida and would be awesome if i could have a look
this should do it. default views should open up to the areas I was just playing with.
1995 Chevrolet Monte Carlo LS 3100 + 4T60E
awesome thanks man! that's next on my list after i meet my current goal of a successful flash!
i've run into this before but i have IDA v6.5 and when i try to load your disassemblies, it tries to upgrade the version of the database, then says 'database corrupt' and bails. never could figure out why
Posting Permissions
Reply With Quote
Bookmarks