I have been reading about what to do to get good data so i can tune my fuel tables. I have a few questions.
1. I am using the AFBW bin. Is this an ok bin to use or is their a better starting bin for a 5.7 with a th400?
2. what is VE as % (FL2) and do i need to tune it or just VE as % (FL1)?
3. I am going to disable PE and work from a little throttle to a lot to try and fill all the blm areas i can. Is their anything else i should disable or any special way i should drive in order to get the best data?
4. The VE table only goes to 3200 rpm so how do i tune for 3200-4500 rpm?
5.I am using the VE correction table for tunerpro. I noticed it only goes to 1800 rpm. Is that all the table can calculate for is 400-1800 rpm? How do i get calculated VE tables for 1900-3200?
Thanks guys i am just trying to make sure i don't mess anything up.
Bookmarks