up load your bin file and I will see if I can help you.
up load your bin file and I will see if I can help you.
here is the Bin....I appreciate you looking at it. I noticed the BLM is freezing so the hi-way mode is engaging. I just need to do some more adjusting to achieve better MPG. 12 mpg SUCKS!!!!
Jason
1987 Silverado V-10 TBI
Goodwrench 350 260hp/350tq motor
3.08 gear 400 trans
Moates Tuning Equip
TunerPro Software
Level, Plumb, and Square
I went to look at your bin it has been saved as a zip file or uploaded as a zip file . tuner pro will open it but it is all corrupted, you might want to start with a nother bin and not save or upload as a zip file.it is coruppeted bad unless it is from uploading or saving as a zip. showed the mask-14, cylinder count 159, I don't think it is a 159 cylinder
which bin file did you start with ?
ASDU3 bin
Jason
1987 Silverado V-10 TBI
Goodwrench 350 260hp/350tq motor
3.08 gear 400 trans
Moates Tuning Equip
TunerPro Software
Level, Plumb, and Square
that is a pretty good bin ,I changed hyway spark adder, some bins with hy lean crusie I would have to go into pe and get it to pick up a knock count before it would enter hy lean crusise. try this bin and if it don't go hlc floor it and see if you can force a few knocks, every thing looks good and should work.
Jason
1987 Silverado V-10 TBI
Goodwrench 350 260hp/350tq motor
3.08 gear 400 trans
Moates Tuning Equip
TunerPro Software
Level, Plumb, and Square
no some bins are that way. if you smooth the timming table then add 1 degree from 50kpa -100 kpa it will knock on its own. look at your table it goes up then down to keep it from knocking adding 1 degree would proble force the knock count. the hlc patch has a forced knock built in it . I would run it an see before tunning any more should work. iam sorry I was thinking of the corrupted bin I looked at, the main spark looks pretty good in this one smoothing would help a little.
Last edited by ony; 08-26-2014 at 04:03 PM.
Bookmarks