interface2.gif
This is how the serial cable is wired. Instead the wire that goes to Pin E needs to go to pin M ?> Can E and M be wired together or do i need to use the two transistor method below?
cablewires.gif
interface2.gif
This is how the serial cable is wired. Instead the wire that goes to Pin E needs to go to pin M ?> Can E and M be wired together or do i need to use the two transistor method below?
cablewires.gif
Reset idle to 850, and re adjusted tps so it's back at .58v at idle all with iac closed.
Reset iac by running engine for 5 secs, off for 10 and then back on. Truck will hardly even stay running long enough to check timing. Timing at 20 degrees or so. About 1/4 advanced from end of scale. Last digit on scale is 16, plus 1/8" after plus the following 1/4".
Bookmarks