Basically 30 degrees on, 60 degrees off then, according to
the cad drawing. With TDC to occur at midpoint. Thats easy enough.
That solves it! I knew someone had to
be doing this thanks for sharing!!!
Basically 30 degrees on, 60 degrees off then, according to
the cad drawing. With TDC to occur at midpoint. Thats easy enough.
That solves it! I knew someone had to
be doing this thanks for sharing!!!
30 degrees / 60 degrees Yes.
The attached pic is designed to mounted to the harmonic balancer also. With the revised design the harmonic balancer will need to have the outer ring of holes drilled and tapped with threads. The advantage of the revised design is it does not interfere with the crankshaft pulley and is very simple / low cost to make!
CAD and / or CNC maching is available, send me a PM for pricing.
dave w
Last edited by dave w; 01-09-2014 at 11:49 PM.
Bookmarks