Hi guys....
I'm building '31 Ford Victoria street rod
383 sbc 700r4 trans 3.73:1 ford nine inch.
Planning to add TPI
Intake manifold I have has EGR which I plan to eliminate. Also set up for cold start injector which I will eliminate also
The ECU I have is 1227747 and I believe the injectors are 19#
I need to Make or modify a wire harness and I'm in need of a good diagram and source for shells and connectors. Or would it be easier to modify an existing harness?
I have a basic understanding of how it all works, and I'm hoping to learn much more!!!
Any help is appreciated and I thank you in advance
Bookmarks