that is the version i was using for quite some time, i'm now using a smaller board for better/smaller packaging, but there were certainly no problems with them.
slightly cheaper, but the main advantage is size.
http://www.ebay.com/itm/New-FT232RL-...item2eca47385e
that style. as you can see, they're not much larger than the FT232RL itself.
i've been intermittently receiving units that require older drivers to work though, for whatever reason that may be caused by.
thank you , greatly appreciated.
ok, so i've pulled the trigger and bought
http://www.ebay.com/itm/New-FT232RL-...47385e&afsrc=1
now it's the waiting game....... guess i'll read over the previous 12 pages again and try to figure out which wires go where
Robert, have u had a chance to test this setup on the '7747 ecm's yet?
If it don't fit force it, if it don't force fit f&%@ it!
Robert, is this the same item u found on ebay? http://www.frys.com/product/6997547#detailed
If it don't fit force it, if it don't force fit f&%@ it!
Ok thanks for the input. Price is cheap enough so Im gonna try it and see. Ill update when i get it connected...hopefully ;)
If it don't fit force it, if it don't force fit f&%@ it!
My unit has finally arrived,
I just reviewed the Cable Installation to TunerPro RT thread, so my com ports are configured correctly in device manager \ TunerPro……. I am also running the correct driver (2.08.14)
http://www.gearhead-efi.com/Fuel-Inj...to-TunerPro-RTNow I’m ready to make my cable, just want to verify what wires im using.
The Rx and the Tx wires connect together which are then plugged into the M pin on the ODB1 socket, then ground to ground (pin A)?
Last edited by freestyle5150; 10-19-2013 at 06:13 AM. Reason: text color
exactly like that for MOST 8192 baud applications will be correct. some will need a switched 10K resistor going from A to B pin, and 160 baud will require connecting the Tx/Rx/ALDL M circuit to the ALDL E circuit, at that point, you're ready to take on everything that uses the 12 pin connector.
awesome, thanks! one last question for today, while configuring my com ports in tunerPro I ran the "test for vaild interface using setting" test. The test failed with a "cable not found or functioning @ 8192 baud" error. Is that to be expected ? I had the FT232RL unit hooked up via USB to the computer, but no cables hooked up to the FT232rl unit.
Bookmarks