I burn my bin file to chip and place in Memcal. I know it would matter which memcal i used for limp home mode, but Im using DIS with timing offset, so my bet would be it would not matter as my 6 cyl memcals have a almost non-existance limphome mode.
To restate my question/statement: I can use the NON-CPI memcals with my bin with no problem (V-6 or 8). When I use a CPI memcal, It will run pretty good at the 2000 RPMs and above and under load. Idle and low load situations, it acts like its loading up and as throttle is applied appears to burn off the excess. I hate to trash the CPI modules as I had already converted them to accept chips. Is it the fueling since I have 2 injectors and it someway CPI is using one?
I dont want to beat a dead horse, but I also hate trashing good chips.
Ted
Reply With Quote
Bookmarks