Well, the car has been jackstand racing for a while, and I'm finally getting somewhere with it. The rear brake and 5 lug swap is nearly complete. I turned down the rotors from 290mm to 280mm tonight to fit with the brackets, caliper hangers and calipers I have on hand. I'll have to measure the old rotors, but I think that's still an inch larger than the old ones.

The front is almost as complete, but ran into a slight snag with the flex lines. The lines I was planning to use are a few days to get, and would be coming from two different warehouses. That means with my luck, I will only receive 1 of them by next week. I'm trying to get the car together again for the 24th, since that's the Brantford Downtown annual car show. So I'm looking at alternate flex lines to use.

Piktarz suun.