Over the last few days I've been working on a TH350 to 4L60E swap in my grandfather's '71 Chev Pro Street (looking) truck.
This truck has an '81 F-body front clip, with a SBC. Most people are able to, with tis front clip, slide the stock crossmember towards the rear and drill new holes. I'm not so lucky, since the floor is pretty low and very close to the tranny, the crossmember did not swoop down far enough, to be able to use it, so out comes the grinders, and welders.
It should be pretty much done except for the driveshaft tomorrow. :)
Bookmarks