New to all this bin tuning stuff. My intro is here if you want more details about the truck. Basically my objectives for the Typhoon is retain a stock bin but adjust what has been tweaked in GMs last MEMCAL tune (1620 BBZB), adjust the boost closer to 14.7PSI (it's spiking to 16.6PSI currently. It was well over 20PSI before some fixes), and reduce the knock retard. That's it. Not really looking for improved performance or skirt-skirting anything that would make the car fail Smog etc. The Ty is all stock H/C/I, Stock trans, Stock turbo/Wastegate, a newish DR152 Wastegate Solenoid, new (yesterday) soldered in pigtail for the Wastegate Solenoid, a disconnected for the time being Greddy Profec boost controller, PLX Wideband - Emulating Narrowband, a Ford Ranger/Aerostar airbox (PCV and driver-side vent hoses hooked up to it) Stock crossover tube was cracked as per SyTy usual, Sportsmachines vac hoses/lower intercooler/Adj FPR(Kirbin?), Aeromotive 11569 340 Stealth fuel pump, 16198263 "Reman By GM Corp." ECU, and a BBZB 1580 MEMCAL. Other than the high boost at WOT, the car is running and idling smooth. Even when hitting 16.6PSI today the engine didn't make a noise and felt smooth. I wouldn't have known how high it was if it wasn't for the Profec warning beeps. I still have the Profec hooked so I can switch between it and the OEM solenoid if I need to.

Here is where I'm at today literally:

AllTogether_NewPigtailOEMSolFullPull.jpg


I'm still learning bin stuff, but I finally have some hardware to play around with.

TyChipStuffEPROMsWriterCode59Starter.jpg

The UV EPROMs I just want to mess with for fun. The two Winbond EEPROMs are what I'll write to and use. I bought a $9 MEMCAL to test the writer and adapters. Worked flawlessly. Wrote a Code59 Starter bin to one of the EPROMS and verified it etc. Again, worked perfect. I haven't installed in the Typhoon yet just trying to learn this stuff at the moment. And I'm not gonna go Code59. You need a 3 Bar MAP, plus their website is gone gone.

OK, My first question is does this look right when stacking a stock Ty bin (16KB) for a 512Kb EEPROM in TunerPro?
BinStackQuestion.jpg

I must be doing something wrong. It says successful, but the resulting file is only 16KB. Also should I check End Justify or it doesn't matter because it's copying the whole 16KB to each block anyways?