No, I have not done any data logging because with the incorrect EPROM the ECM was in limp home mode. Also, when I connected a scanner to the ALDL, I was not able to read any codes. Once I installed the EPROM you sent with the AKDX bin, the motor ran fine initially. After 4-5 restarts, the motor began to falter and struggled to idle smoothly. From that point on, it was hard to start and I could see heavy streams of fuel (not a fine mist) pouring from the injectors. I suspect one of the areas in need of some attention will have to be the idle fuel mixture.

Now with the AKDX installed, my next objective is to figure out how to data log using my AutoPROM.