Quote Originally Posted by steveo View Post
so what happened is the second part of the erase program was uploaded. usually it would respond with a message 0x55 for each stage of the erase procedure, and 0xAA when complete. i've never seen a message 0x06 response, but the checksum is correct, so it's a legit message.. i'll have to do some disassembly and try to figure out what makes that occur.

this might be the program bitching about starting the erase procedure, but that means your ECM should still be in a useable state? so it's more likely it started trying to erase and something went horribly wrong
The car wouldn't start, just turn over. I also couldn't get the program to connect any more.
The fans didn't come on, which I understand happens when you brick the ecm. I didn't try resetting it by removing power or pulling the fuse. I didn't have the time though, I just swapped out my spare so the car would run.