Last year I added a 1227747 to the 305/4L60 in my 4 wheeler. After a couple months of adjusting it is running great. I recently added an on-board air system that uses a York A/C compressor. I would like a higher RPM for filling the air tank and getting more output from the alternator while winching. I wired the compressor power switch to the A/C wire on the computer, but it did nothing. Diving into my last bin file all 6 scalars I found for A/C are zero. So, I am looking for some settings from a similar engine/trans combo. I went through a bunch of bin's from the site here, but the values are all over the place.

I only see 6 objects, all under IAC (Using TunerPro RT):
1. Init for A/C on Steps
2. Added Started Steps w/AC on
3. Min Diff. Steps w/AC on
4. Max Diff. Steps w/AC on
5. RPM Added to Desired Idle w/AC on
6. RPM Added for A/C On


This is from ADTJ G-Van 5.0l
1. 25
2. 22
3. 5
4. 35
5. 0
6. 0

This is from APYP
1. 133
2. 195
3. 209
4. 223
5. 2475
6. 2325


As you can see the values are vastly different. What works for you? Any other settings I am missing?

Thanks,

Steve