Just bought a Asnu-01 injector flow bench tester. It came without any accessories. It uses a standard computer power cord and it turns on and lights up. Now I was wondering what fluid can I put in it just to check and make shure the fuel pump and regulator work? Also I have taken it apart to try and see how to wire up the injector harness. I have pics of the circuit board. The injector plug uses a femal 20 pin atx power cord.Attachment 9367 The plug on the right is the injector plug. The lower pins odd numbers 1-19 are all tied to the ground circuit. Now the top pins even numbers 2-16 are all tied to the white resistors that go to the next to last large mosfet on the top shiny heat sink rail. Am I right that they are driving 8 injectors at the same time and are doing it on the hot side instead of the ground? Will that kind of driver work for all types of injectors, high ohm and low ohm? Then there is pin 18 that shows to be a spare injector driver and has nothing on it. Then there is pin 20. It runs to the last little mosfet. What could pin 20 be for? I'm no electrical engineer so I might be wrong on some of my terms. I'm still learning
Bookmarks