Hey guys,

Working on the XDF for my trans controller project and having a little issue displaying the data properly. Not sure(but likely is) if it's my fault in the code or how Ive set up the XDF but I have tried several ways. Anywho, when I open a table, say 1-2 shift MPH vs TPS%, instead of the value showing up on one line, 20% throttle = 18MPH, the "1" is on one line and the "8" are on the next line down. I have tried viewing as hex, integer, float, and ASCii and it always separates the value for some reason. Anyone have any ideas?

Thanks in advance,

Buddrow