Quote Originally Posted by gregs78cam View Post
See I would go that route for my application since I already have the Dual TBI setup with an external regulator, only problem is the wimpy 1/8"NPT ports. I would have to machine it for -6AN, that's if there is even enough material to do so. Or buy the Mallory for $120.

I was just helping Dave out with his idea.

Dave, I was going to try to turn one out next week, but I am in the process of re-powering the lathe to try get rid of a vibration from the variable speed belt setup. So it may be a couple of weeks before I get parts. I might try to get part of it done this week at work if I have time.
Hav'nt seen much of you since you bought that lathe/mill... my kid ruined another 5 gallon bucket of used oil for your heater with water/antifreeze... again... stop by if you have time in town.