These numbers are good for 96 also.
The reluctor wheel used in 96-00 l29 is p/n 12561074.
If these match and the sensor is good, only possible reason could be the space between wheel and sensor.
These numbers are good for 96 also.
The reluctor wheel used in 96-00 l29 is p/n 12561074.
If these match and the sensor is good, only possible reason could be the space between wheel and sensor.
Does anyone know what the output voltage of the Vortec 454 crank position sensor is supposed to be? I have two used crank position sensors (not sure what make / model / year they are from) and the output voltage is 5.25 volts DC. I just purchased a new Standard Motor Products (PC123T) Vortec 454 crank position sensor and it has an output voltage of 12 volts DC. When the trigger wheel passes the crank position sensors I have the output voltage goes to 0 (ZERO) volts DC.
I did some research and the 454 sensor output a frequency to pcm, and for diagnostics some duty cycle in hz is measured.
It gets some B+ voltage so it is possible the output be around 12v.
For comparison Ls crank sensor output 4-6v signal.
Could a 96-97 lt1 crank sensor be used in the ramjet engine.
Glad she fired, here is the actual marine part number for future reference
$94
8M0011986 SENSOR ASSEMBLY, Cam Position
These CKP sensors are very sensitive to install, I have found that if I install the sensor then use the screw to draw the sensor in they don't work, but if I insert the sensor, then give it a push to ensure its in there flush, THEN tighten the screw it'll start.
peace
Hog
Bookmarks