N/A application, if you didn't want to touch the BPC value, how would you compensate for areas of a VE table that want to go higher than 100% ? BPC should be 127 and are currently set to 135 to scale up table.
N/A application, if you didn't want to touch the BPC value, how would you compensate for areas of a VE table that want to go higher than 100% ? BPC should be 127 and are currently set to 135 to scale up table.
EBL- port version. 385cid with 36pph injectors and 43.5psi fuel.
in rough terms, figure out how far you need to go, say X=10%.
the higher you go the less remaining VE resolution you'll have, but if your ECM uses 16 bit VE it wont matter much.
go ahead and scale whatever constant your calibration uses for base fueling by X%, and subtract X% from your VE table.
then go ahead and modify your XDF add *1.X to the conversion formula for your VE table.
ve table should look exactly like before, but now you have X% of headroom.
this works in theory but in practice it'll twiddle your VE numbers a bit and need some fine tuning.
BPC = 730.75 * (Volume / Injector Flow Rate)
The Injector Flow Rate in grams per second
The Volume of one cylinder in liters
dave w
Does BPC require that the FPR be manifold referenced...?
Is there any provision for un-refetenced ("dead head") FPR to handle BPC and IFR...?
Bookmarks