Thanks, Elky. Sorry took so long, have family issues going on in Central FL needing tending to.
I do have a mechanical background, but it's old. Updraft carbs and magnetos, manual injection diesels and solid roller camshafts type of old. So essentially from heads down I understand it. Everything with a wire to it, in this context may as well be 100% new to me, so not going to offend me asking anything. I appreciate the help and if I get to the point where I've worn out my welcome - perhaps I'll have enough knowledge to not drown.
Loaded the BIN on a chip, and it runs fine - very similar to the old .BIN file from a sound/drive feel. It takes more spins to start it now, (that's something I've been paying attention to, and will troubleshoot later, but each .BIN I've loaded has had different characteristics when it fires up the car - I thought it fired up the car based on the cold start info on the original MEMCAL)
Done - Make sure your IAC/TPS are properly set (Google for TPI instructions). Recommend 0.6v at 0% TPS
Done - Ensure your dist is set at 10 deg with bypass disconnected or change bin accordingly
Don't know how - yet. - Increase idle spark from 20 to 21 or 22 deg and use those values from 400-800 RPM all kPas. Then at 1000 RPM, same value for 40-60 kPa. That makes spark always the same for idle. Smooth around 1000 area and transitions to off-idle.
Not sure I understand this. Is this in reference the above sentence?-Despite AL heads, ensure you need that much spark above idle.
- User TPro difference tool and compare your new bin with the uncalibrated released S_AUJP bin. Pull into your bin any things that seem strange they were changed in your custom tune. Like:
What does this do?---Switch 18 (0x018) - Bit 1 - Reset INT to 128 when in AE (Y/N)
What should this be?---Spark Latency Correction (Should only be changed by someone on a dyno. Maybe the tuner copied that from some other tune. Should rarely be changed.)
Does this indicate a need for a lower thermostat, or incompetence in original coding of the .BIN?---SPARK ADV, Temp. Correction .vs. Load .vs. Coolant Temp. Current settings providing too much spark below 133 deg. All entries should be 20.04 to match the coolant bias Scalar to yield 0 deg change
I am unsure. What modifications would necessitate a PE Spark advance? Is this primarily for pressurized applications? ---PE Spark Adv. Is this really needed with all you now have?
---etc . . . . .
Bookmarks