When I was testing some stuff with boards off the case I put some thick paper between 2 boards to prevent possible short issues and connect ground to each board from the connectors. a2 and d1 pins do the trick with grounds.
i had a ton of beer and resocketed this thing with a propane torch. greenwired it with fluxed up bailing wire when one of the traces ripped. the plywood that the ecm is screwed to is warped but i just cranked it down anyway. the screws were too long and it was squeeking the glass so i just threw some scrap foam under it. works fine. fbodytech is a drunken basement operation. time spent making things pretty just takes time away from coding.
edit: should also mention that that screw terminal block looks solid but none of the ring terminals i had in stock were the right size, so i just cut the things off. they're barely in there.
Hiya,
Does anyone know if the hardware of the obd1 and obd2 pcm's are the same? My 94/95 never showed up. Just wondering if I can socket and just swap chips so I can continue experimenting?
-Carl
Bookmarks