Very cleanly done, looks like a great start!
Very cleanly done, looks like a great start!
Does anybody know whats the logic on 16197427 Ecm Pin F6 (fuel pump control to relay). Is this for prime only, or does it keep the relay energized to share the fuel pump load with the grey wire on the oil pressure switch?
When I wired mine, i didn't run it through the oil pressure circuit. One wire powers the relay for running the fuel pump and one wire lets the computer know the fuel pump relay is working. Don't remember which.
The stock configuration as I'm seeing it:
Battery +12V (Orange) feeds the pump relay, the oil pressure switch, and (Hot at all times) to the ECM Pin E16
Fuel pump relay control from the ECM (DK GRN) pin F6 controls the relay
Relay and Oil Pressure switch feed the fuel pump when energized (relay energized, oil pressure switch pressurized)
This Pump feed is Grey and also feeds the ECM (relay working) on pin B12
What has me wondering is if the relay is on all the time, the fuel pump would run regardless of the oil pressure switch position, which i would assume is there to kill the fuel pump in the event of no oil pressure.
If this is the case, I would think that the oil pressure circuit is usefull only in the case of a relay failure.
no it does not kill the fuel pump if there is no oil pressure. the circuit is there so if the relay fails the pump will still get power once the engine has 3 or more psi. i suspect the circuits being tun in parallel will reduce the amperage across the the relay contacts but the main reason is to have an alternate means to supply power to the fuel pump.
Thanks for the response tayto, all my research says you are correct. Redundant circuits.
Bookmarks