PE enabled, but not activating (0411 8322)

[woody80z28]

One of the first things I did to tune my 8.1 was to enable PE by changing the delay timer from 60sec to 0sec and TPS enable from 90 to 70%.

I also noticed it didn't seem to do much, so I put a wideband in it. Well, at WOT it's showing me 14.8-15.1 on the wideband. I can see the TPS% at 99 in the log.

I am logging a couple more degrees spark (as I added), and the fan control I added is working - so I know the tune and flash process is functional.

There's gotta be something I'm missing here. Any idea what I could be doing wrong? BIN attached.

[steveo]

does your datastream output a flag for power enrichment active? is it being set?

[Fast355]

One of the first things I did to tune my 8.1 was to enable PE by changing the delay timer from 60sec to 0sec and TPS enable from 90 to 70%.

I also noticed it didn't seem to do much, so I put a wideband in it. Well, at WOT it's showing me 14.8-15.1 on the wideband. I can see the TPS% at 99 in the log.

I am logging a couple more degrees spark (as I added), and the fan control I added is working - so I know the tune and flash process is functional.

There's gotta be something I'm missing here. Any idea what I could be doing wrong? BIN attached.

Set enable KPA to 55 and enable torque down to about 70%.

[woody80z28]

No flag, I'm logging with TunerPro via bluetooth. Limited PIDs.

MAP PE is at 55 already. I don't see anything in this XDF about "enable torque." There's enable TPS, and I've already changed that from 90 to 70. And my TPS is reading 99 in the log.

I have my PE EQ ratio set at the stock 1.240 for B3618 PE modified based on RPM
B3617 PE coolant temp and B3641 intake temp are both full of 0s, but it says they are added, not multiplied. So I don't think they would be causing an issue.

[woody80z28]

So I opened up HPTuners and a random 8.1 file I had downloaded and I do see the PE enable torque % is set at 100. MAP is set at 55, MAP hysteresis is 6% and torque hysteresis is 15%. Neither of those torque settings are visible in TunerPro. They are labeled 2414 and 2413 in HPT, but PE delay is 2415 in HPT and it's labeled B3608 in TPRT.

[woody80z28]

Bump. Anyone know a way to convert a .HPT file to .BIN perhaps?

[In-Tech]

I changed Power Enrich Enable Torque Threshold to 0% like in the Camaro/Transam. Pretty sure I got the checksums all correct.

CONSTANTS:
 
 
	Fuel Parameters
 
		Power Enrich Enable MAP                                   55 Kpa
		Power Enrich Enable Torque Threshold                     100 % Torq.