I'm new to Tunerpro and some of the basic functions are probably very simple, however I have no idea what I need to do here.
I'm working on a 94 z-71 5.7.
ECM#16196395
Starting BIN File: BJLF (this is straight off the PCM)
XDF File - Advanced $0D TP5 v250.xdf (I've even tried the $0D TP5 v250.xdf straight from the tunerpro downloads page. even tried the $0E.XDF)
Definition - A217_0D_v250 - 4L60

For starters I cannot emulate. I'm using the Moates Autoprom. It will start out fine and slowly start glitching until it either wont shift or wont run, however I can burn a chip and it's hit and miss. Yesterday it ran but was commanding 23,000 degrees of timing randomly throughout the RPM Range. Pulled the chip and re-installed the original and it worked fine. I have an old Hypertech chip for the truck. I can put it in and it runs great, so that tells me it's not a computer issue. Still stumped. when it starts crapping out it starts throwing all kinds of random codes like EPROM ERROR, Fuel pump relay, etc. So far the Datalogger works, but again when it starts crapping out I loose tach, TPS% and so on while logging. So far I've had better luck programming under $0E than I have $0D. I have the switches in the correct locations on the Autoprom. (both pushed towards one another.) When I put it in pass-through it stops all-together. I do not believe I have an issue with any hardware as I recently tuned a 91 Camaro and everything worked fairly well. It was a little glitchy and I had to constantly upload the BIN or it would start to freeze up. It has to be something i'm not doing correctly. Just for curiosity I checked the Hypertech chip's Mask ID and $0D is what came up. so I'm not sure why the $0E worked better.

While I'm at it here's another question - I'm wanting to watch and compare the Desired AFR to what i'm getting on the wideband and when I go to the values tab there is a message in the box that says "For data logging "Desired ARF" instead of "Battery Voltage". The bin must be change at L520C to support this." I have absolutely no idea what I need to do here and cannot find anything in the forum about it.

Thanks in advance for the help.