This is a brand new install with an older Edelbrock MPFI and a Dynamic EFI ECM.
I got some backfires early on but now nothing. I have spark as verified by getting the timing set to 0 with a light.
Where to start?
This is a brand new install with an older Edelbrock MPFI and a Dynamic EFI ECM.
I got some backfires early on but now nothing. I have spark as verified by getting the timing set to 0 with a light.
Where to start?
I would double check that the distributor rotor is correctly aligned to #1 cylinder spark plug wire for Top Dead Center of the COMPRESSION stroke and then verify the correct distributor firing order.
dave w
I have an update before it got dark and cold.
I noticed a substantial amount of gas running from the right header so I may have a stuck injector.
I have fuel pressure when I jump the pump solenoid but it leaks down almost immediately
Bookmarks