Trying to figure this out to get the correct readings and adding templates to my .adx file.
I have this for the inj DC% and have seen it in multiple adx files but from reading on the forum I have heard different results as it only reads 1 injector and you have to double it.
<MATH equation="(X*4*Y)/1200">
I have rad to possible add multiply by 2 needs to be added.
I ask because I get max mid to high 50's for inj DC% and if this is the case and I need to multiply by 2 for 2 injectors then I am over 100%
I get high 11's to low 12's with the wbo2 at WOT but the fuel psi is dropping about .5, trying to figure out if I need a bigger pump(have tpi pump with 65pph inj @ 24psi 350hp 355ci motor) or inj are just pushed too far and need more psi at the vfpr.
I get high rpm very slight degraded performance like a miss or under powered for split sec.

So if anyone has any info on the equation that would be great.

thanks for your time