Results 1 to 3 of 3

Thread: Mimic A/C control canbus signal to PCM

  1. #1
    Carb and Points!
    Join Date
    Mar 2017
    Age
    36
    Posts
    2

    Mimic A/C control canbus signal to PCM

    I have a 2010 LV3 that I swapped into my '95 pathfinder. Got it running like a top and now I'm trying to get the A/C working. The issue is there is no pinout on the PCM to tell it to engage the A/C compressor clutch. I believe it would normally get this signal from another module on the canbus and the signal is digital. What I have been trying to do is figure out how to mimic that signal on the canbus. Obviously this is not a simple task and there will be some programing, but I am wondering if anyone else has accomplished or even tried this? Or any leads on an aftermarket solution. I know that its possible to hack the canbus and feed it data.

    The easy solution here, I am ignoring for now, is to create an isolated system that operates independently from the PCM. But this isn't as elegant and it would be nice to have the PCM take care of the whole situation the way its designed to. I know that the engine will recover at idle from the load as it does for the power steering, but once again just nicer to let the PCM handle the A/C timing.

    Any thoughts?

  2. #2
    LU3? LV3 is a DI 4.3 that come out in 2014

  3. #3
    Carb and Points!
    Join Date
    Mar 2017
    Age
    36
    Posts
    2

    Correction LU3

    Quote Originally Posted by Skinny Pedal View Post
    LU3? LV3 is a DI 4.3 that come out in 2014
    Pardon me. Yes an LU3.

Similar Threads

  1. ALDL bad/no signal
    By trickster555 in forum GM EFI Systems
    Replies: 1
    Last Post: 05-10-2016, 02:42 AM
  2. 2012 LFX V6 - From Camaro - Manual Trans. - E39 PCM - CANBUS - Run stand alone?
    By Raydar in forum Fuel Injection Writeups Articles and How to New and Old
    Replies: 5
    Last Post: 03-01-2016, 09:05 AM
  3. VSS signal converter
    By sturgillbd in forum GM EFI Systems
    Replies: 18
    Last Post: 05-09-2015, 02:34 AM
  4. o2 sensor signal
    By bonnieclyde100 in forum GM EFI Systems
    Replies: 5
    Last Post: 03-09-2014, 09:35 AM
  5. Why do I not have 5v coming from B12 (MAF Signal) at the ECM?
    By BurgerWorld in forum GM EFI Systems
    Replies: 50
    Last Post: 08-30-2013, 07:41 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •